- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Aruba & ProVision-based
- >
- Configure a stack on an existing switch
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО04-26-2018 03:04 AM
тАО04-26-2018 03:04 AM
Hi everybody,
I have a 2920-48G in production and i just received a 2nd 2920-48G (with stack module).
I have installed the stack module on eatch switch, I have rebooted all switch and the stack module is OK (LED is OK).
Before active the switchs in stack mode and connecte the stack cable i have one question !
My 1st switch contain a configuration, the 2nd is empty. When i active the stack mode and reboot my devices my configuration stay in place ?
Thank a lot for your reply,
C├йdric
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО04-26-2018 06:27 AM
тАО04-26-2018 06:27 AM
Solution
@Cedric33 wrote: My 1st switch contain a configuration, the 2nd is empty. When i active the stack mode and reboot my devices my configuration stay in place ?
Hello Cedric, yes...your configuration on the Commander will be preserved (by the way...a backup is always a good thing to do before any relevant configuration change...see it as a best practice).
Please refer to these HPE documents:
- HP 2920 Switch Series Stacking (Technical Whitepaper).
- HPE 2920 Switch Series - Stack configuration and adding new member in stack (HPE Knowledge Article: mmr_sf-EN_US000005397).
- HPE 2920 Switch Series - Stack Factory reset AKA if you're going to re-deploy a previously used Aruba 2920 member of a Stack as a new standalone switch (HPE Support Information: mmr_kc-0129445).
I'm not an HPE Employee
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО04-26-2018 08:34 AM
тАО04-26-2018 08:34 AM
Re: Configure a stack on an existing switch
Hi,
Thanks for this confirmation.
I have plan to take a backup before this operation !
Regards