Hewlett Packard Enterprise Community
Help
cancel
Turn on suggestions Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

HP Storageworks 1/8 Autoloader

Highlighted
Mohd Norazri
New Member
‎02-28-2004 08:25 PM
‎02-28-2004 08:25 PM

HP Storageworks 1/8 Autoloader

Message contains an attachment
Unable to run backup under Win 2000 Adv Svr, but works fine under Win 2003 Adv Svr. error: 'Cannot detect the selected backup device'. I'm using W2K standard backup software. On HP L&TT software, there is a message required me to enter factory password when I want to open backup log. Where can I get it?
0 Kudos
2 REPLIES 2
meloni
Honored Contributor
‎02-28-2004 10:25 PM
‎02-28-2004 10:25 PM

Re: HP Storageworks 1/8 Autoloader

Hi,

the password is available to support agent only, and anyway usualy there is not more usefull information inside that those you can read in the support ticket, In you case, what is the Backup Sw you are using? NTbackup in W2k do not support media changer, but should detect the drive inside.
Be sure you don't have installed previous BU SW or Utility that are running in the background keeping ownership of the tape drive.
---------------X-------------------X--------------------X----------------X--------------
If everything is under control, you are going too slow (Mario Andretti)
0 Kudos
Mohd Norazri
New Member
‎03-04-2004 02:45 PM
‎03-04-2004 02:45 PM

Re: HP Storageworks 1/8 Autoloader

Currently I'm just using W2K standard backup. Actually, I've successfully do the backup, but sometimes some error 'cannot detect the selected backup device' even though the tape is inside. Same prob happen if using new tape. After any success backup, there will an error on tape screen 'unload prevented by scsi command' when I need to unload the media.
0 Kudos