HPE Community
BladeSystem - General
1819551 Members
2501 Online
109603 Solutions
New Discussion

Re: Active/active SUS becomes Active/standby after upgrading Flex10 firmware (2.33 -> 3.01)

 
Bakker101
Occasional Visitor

‎08-05-2010 11:13 PM

‎08-05-2010 11:13 PM

Active/active SUS becomes Active/standby after upgrading Flex10 firmware (2.33 -> 3.01)

I applied scenario 2-3 of the VC cookbook  and got the expected result: active/active SUS. After upgrading the firmware to version 3.01 this became an active/standby SUS. The release-notes don't mention anything about this. So, am I doing something wrong?

0 Kudos
Reply
1 REPLY 1
Stevem
Frequent Advisor

‎08-27-2010 01:25 PM

‎08-27-2010 01:25 PM

Re: Active/active SUS becomes Active/standby after upgrading Flex10 firmware (2.33 -> 3.01)

Did you get this resolved?

 

What changed with teh config, other than the VC FW upgrade?

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.