HPE Community
BladeSystem - General
1752700 Members
5561 Online
108789 Solutions
New Discussion

BL460c G7+ Slackware 12.1+ network configuration

 
galam.sunilyadav
Advisor

‎09-22-2011 06:28 AM

‎09-22-2011 06:28 AM

BL460c G7+ Slackware 12.1+ network configuration

Hi experts,

 

have installed slackware 12.1 on BL460c G7. manged to install.

unable to see network interfaces in the ifconfig -a output.

only loopback is visible.

 

Tried to boot from Knoppix live cd, able to see eth0 and eth1 in the output of ifconfig.

there are no drivers available in the hp website. kind of dead end.

please advise.

 

manythanks in advance.

0 Kudos
Reply
1 REPLY 1
Johan Guldmyr
Honored Contributor

‎09-22-2011 09:51 AM

‎09-22-2011 09:51 AM

Re: BL460c G7+ Slackware 12.1+ network configuration

Check what drivers are used on the knoppix. Maybe that would give you a clue?

Knoppix is based on Debian.

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.