Blade p-class iLO auto disconnect when launch brower to logon

[dihung]

Hi All,

We have 3 x blade p-class enclosure installed with enhanced backplane components, i.e. a iLO port in the rear.
I have 2 questions about the settings and problems of iLO.
1. We connect iLO port to the front 2 x ports of switch A and B, i.e. 3 of 4 ports in the front switch A and B connected to iLO ports of blade. Is it connection correct?

2. We found that we can ping the iLO port of blade server after set up iLO settings through "F8" during boot up. But we found the ping test connection will lost immediately when we try to open a browser and enter the blade server iLO ip to connect. Is there any suggestions?

Thanks a lot your help.

Best Regards,
Dic