HPE Community
BladeSystem - General
1820325 Members
2675 Online
109623 Solutions
New Discussion

Blade VC direct connect to a 4-node 3par cabling

 
dennischen
Advisor

‎10-18-2016 03:37 AM

‎10-18-2016 03:37 AM

Blade VC direct connect to a 4-node 3par cabling

Hi everyone,

IHAC is using RX9900 blade(with two 10Gb/24 FlexFabric VC module) to direct-attach to 4-node 3par 8400. And I have a question about the cabling between the VC and 3par nodes.

I have two plans, not sure which one is supported and recommended. Thanks for the help!

Plan A, 

vc to 3par_2.png

Plan B,

 

vc to 3par.png

 

 

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.