HPE Community
BladeSystem - General
1849016 Members
1822 Online
104040 Solutions
New Discussion

BLc VC Flex-10/10D Module Opt how upgrade from 4.50 to 4.85 when are managed by OneView

 
SOLVED
Go to solution
WilliamSmith11
Super Advisor

‎09-19-2022 02:06 PM - last edited on ‎09-21-2022 03:41 AM by

‎09-19-2022 02:06 PM - last edited on ‎09-21-2022 03:41 AM by

BLc VC Flex-10/10D Module Opt how upgrade from 4.50 to 4.85 when are managed by OneView

Hi 

We have a pair of  HPE BLc VC Flex-10/10D Module Opt  in a C7000 enclosure

We have upgraded all the components , but was not possible upgrade the pair of Virtual connect using VCSU because cant communicate with any of the VC. We can make ping.

The C7000 is managed by OneView.

How we upgrade the VC from the version 4.50 to the latest 4.85.

Regards

Williams

 

rperez
0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎09-20-2022 08:44 AM

‎09-20-2022 08:44 AM

Solution

Re: BLc VC Flex-10/10D Module Opt how upgrade from 4.50 to 4.85 when are managed by OneV

Once under OneView control you can use Oneview only to upgrade the firmware.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.