BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Can we add IP v4 static route in Onboard Administrator

 
SOLVED
Go to solution
Highlighted
Occasional Contributor

Can we add IP v4 static route in Onboard Administrator

Can we add IP v4 static route in Onboard Administrator. I can this command for IPv6 but not for IPv4

 ADD OA ADDRESS IPV6 [{<bay number>}| ACTIVE | STANDBY] <ipv6 address/prefix
length>

2 REPLIES 2
Highlighted
HPE Pro

Re: Can we add IP v4 static route in Onboard Administrator

Configures the OA to IPv4 static mode or DHCP mode.


In STATIC mode, the IP address and netmask are set to the specified <ip address> and<netmask> respectively. These settings take effect immediately. If the gateway address and/or DNSaddresses are not specified, they are cleared. The gateway and DNS address can also be set by usingthe SET OA GATEWAY and ADD OA DNS commands. The command syntax for setting static mode isas follows:

SET IPCONFIG STATIC [<OA bay number>] <ip address> <netmask> [<gateway>[<DNS1 address> [<DNS2 address>]]]

For more information please refer HPE BladeSystem Onboard AdministratorCommand Line Interface User Guide (Page Numder 115)

https://support.hpe.com/hpesc/public/docDisplay?docId=c00702815

I am an HPE Employee

Accept or Kudo
Highlighted
Occasional Contributor
Solution

Re: Can we add IP v4 static route in Onboard Administrator

My observation, IPv4 static route couldn't be added in OA