BladeSystem - General
1745904 Members
4268 Online
108723 Solutions
New Discussion

Re: Configuration of Nortel 8600 core switches for Virtual Connect

 
Erik DT
Occasional Contributor

Configuration of Nortel 8600 core switches for Virtual Connect

Hi,

Anyone has experience with the network configuration that is needed for Virtual Connect to work. I found documents for Cisco & Procurve but nothing for Nortel.

Problem that we have is that we have 2 switches, each one goes to a virtual connect module.
We enabled LACP so when one of the switches fails, the other one takes over. But that doesn't happen.

I just would like to know if someone managed to get this configuration to work.

Thanks,
Erik
1 REPLY 1
JonathanT
Frequent Advisor

Re: Configuration of Nortel 8600 core switches for Virtual Connect

I got it working on the Dell PowerConnect 6248 switch. I can send you my port and channel configuration commands if you think that would help you out at all.