MAC address display as all zeros in OA

[ThomasN]

Hi All,
I have a c7000 enclosure with BL460c G1 blades using the HP 1GB Ethernet Pass-thru module. When in the port mapping view of the Pass-thru module under Interconnect Bays in OA I see the embedded Ethernet MAC addresses as all zeros and the iSCSI MAC displays fine for all my blades. I don't have any connectivity issue but is this normal or do I have a misconfiguration somewhere? Attached is a pic of what I'm talking about. Thanks.

[Oleg Koroz]

This is won't be misconfiguration and rather informational error, that should not effecting on your production environment, you have and Mezz FCA installed or to install from anotherhow many servers has the same problem ?

[Raghuarch]

Hi Thomas,

What is the version of OA and iLO you are using.
In the iLO are you able to see the MAC address of the NICs.
Please refer to the attachment.

Regards,
Raghuarch

[ThomasN]

Hi Raghuarch,
I don't see the attachment. Please repost. thanks.

[ThomasN]

Hi Oleg,
No I don't have a Mezz FCA installed and this is affecting all my blade servers. Thanks.

[ThomasN]

Raghuarch,
Yes, I can see the MAC addresses in iLO.
OA = 2.04
iLO = 1.35

[Mi6t0]

ilo is too old - please, try updating to 1.42

[Raghuarch]

Hi,

Upgrade to iLO 1.42. available in below location.
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=US&swItem=wk-55490-1&prodTypeId=15351&prodSeriesId=1842750

Regards,
Raghuarch

[Raghuarch]

Hi Thomas,

Even after all the iLO's are updated the MAC address is shown as zero.

Reset your OA.

Note: Reset OA if the iLO upgrade doesn't fix the problem.

Regards,
Raghuarch