HPE Community
BladeSystem - General
1758186 Members
2763 Online
108868 Solutions
New Discussion юеВ

Re: Scripting the setup of a virtual connect

 
SOLVED
Go to solution
Jimmy Vance
HPE Pro

тАО10-07-2011 05:36 AM

тАО10-07-2011 05:36 AM

Re: Scripting the setup of a virtual connect

I'm not sure when the command was added, it's in v3.30

No support by private messages. Please ask the forum! 
0 Kudos
Reply
Johan Guldmyr
Honored Contributor

тАО10-07-2011 05:41 AM

тАО10-07-2011 05:41 AM

Re: Scripting the setup of a virtual connect

Maybe it's possible to get the config out from the 'show all' ?

0 Kudos
Reply
Ctl2011
Member

тАО10-07-2011 06:35 AM

тАО10-07-2011 06:35 AM

Re: Scripting the setup of a virtual connect

Show config is new command in 3.3. Below is the extracted from the 3.3 release note.

 

тАв New CLI commandsтАФNew CLI commands to support save and restore configurations, copy
profiles, and the show config command that generates a CLI script that can be used to restore the
current VC domain configuration

Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.