HPE Community
BladeSystem - General
1753399 Members
7129 Online
108792 Solutions
New Discussion юеВ

Re: Usage of nc360M Ethernet module for Cluster Interconnect

 
Habich
Occasional Advisor

тАО02-17-2010 02:06 AM

тАО02-17-2010 02:06 AM

Usage of nc360M Ethernet module for Cluster Interconnect

I want to build a solaris cluster between to blades in an enclosure. my solaris installation has found 2 ethernet interfaces (e1000g0, e1000g1) which i want to use for 2 cluster interconnects.

How do i have to configure the virtual connect manager to get a network connection between the two blades?
0 Kudos
Reply
2 REPLIES 2
JKytsi
Honored Contributor

тАО02-17-2010 03:34 AM

тАО02-17-2010 03:34 AM

Re: Usage of nc360M Ethernet module for Cluster Interconnect

Create a network without any uplinks. then map that network to NICs which You want to use in cluster traffic.
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Reply
The Brit
Honored Contributor

тАО02-17-2010 04:41 AM

тАО02-17-2010 04:41 AM

Re: Usage of nc360M Ethernet module for Cluster Interconnect

As pointed out by Jarkko, create a VC "Ethernet Network" but do not assign any ports to it.
Then in the server profile, assign this "clustering" network to the Port(s) which you want to use.

Dave
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.