HPE Community
BladeSystem - General
1757014 Members
2367 Online
108858 Solutions
New Discussion

VC Ethernet module failover

 
Thomas Duncan (HSA)
Occasional Contributor

‎06-17-2008 04:49 PM

‎06-17-2008 04:49 PM

VC Ethernet module failover

Is there a specific sequence to replace a primary VC-Enet module that has failed? (Like the OA where you pull the secondary module and install it in the primary bay and then install the new unit in the redundant bay).
I’ve spent a little time in the user guide, but not found the scenario.
0 Kudos
Reply
2 REPLIES 2
JKytsi
Honored Contributor

‎06-17-2008 11:35 PM

‎06-17-2008 11:35 PM

Re: VC Ethernet module failover

So your primary one has failed ? The secondary VC module takes it's place and when you insert a new one to bay1 it will sync the data and you can do a manual failover back to bay1 from VC manager tools.
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Reply
Thomas Duncan (HSA)
Occasional Contributor

‎06-18-2008 09:54 AM

‎06-18-2008 09:54 AM

Re: VC Ethernet module failover

Thank you.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.