- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- 2910AL and static routes ???
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-19-2011 02:12 PM
09-19-2011 02:12 PM
2910AL and static routes ???
Hello All,
I'm new to configuring procurve switches.. but I'm a fast learner?
I have an untagged(native network) that I'm trying to route traffic to a VLAN.(tagged)
I enabled routing.. it was my understanding that once I enabled routing.. then traffic will automatically begin routing?
Am I missing something? I didn't think I had to create any static routes?
Also, when I show ip route... I see route types of static and connected? What is type "connected"?
Thanks,
Dan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-20-2011 10:16 AM
09-20-2011 10:16 AM
Re: 2910AL and static routes ???
Hi,
yes, for directly connected networks (VLANs) just assign ip addresses, enable ip routing and the switch can route between them. For any network that is not in routing table and you want to route to them you have to create static route or default route or implement dynamic routing protocols such as RIP or OSPF between switches/routers.
"connected" route type means that the switch has local interface (port in some VLAN in case of 2910al) in this network and can automatically install routes for them (based on ip address and subnet mask of this interface) in the routing table. To appear in the routing table there has to be at least on port active in this network/VLAN.
Regards,
Jan