A7510 giving error Not enough resources

[RajRaj]

Hi,

After executing command port link-mode route on Gi11/0/2, command gives the error:-

Action fails: Not enough resources!

At the same it is working on port Gi11/0/1 , but it goes in hang mode and after doing shut and undo shut it starts working.

interface GigabitEthernet11/0/1

port link-mode route

ip binding vpn-instance srv-frm

ip address 1.1.1.1 255.255.255.252

#

[H3C-GigabitEthernet11/0/2] port link-mode route

Action fails: Not enough resources!

Can anybody tell what is the reason for this? Switch is running in standalone mode.

Thanks

Raj

[pombeii]

Your software release?

[manuel.bitzi]

Hi RajRaj

Software versions and blade/fabric types please. BTW: SA-Blades dont support routing-mode.

display version

display device

br

Manuel

[cypris]

What was the problem?  I have a similiar issue trying to execute the "port link-mode route" on an HP A5800 series switch and I don't know what the error is telling me "specifically"...  Thanks.

[Peter_Debruyne]

Hi,

the routed port configurations are not always available for all interfaces.

Last time I tried it (about 1,5 year ago), the 7500 supported it on the ten gigabit, but not always on the gigabit ports.

Same applies to the 5800 !

So just test it and accept if you get an error ... (or log a case with support, but I would believe it to be some ASIC restriction)

Best regards,Peter.