Error Firmware 3Com Baseline 2924

[jmcristobal]

Hello friends I have a problem with a switch 3com Baseline Switch 2924 - SFP Plus (3CBLSG24), the detail is that when you start sends this error

Network Switch based on 88E6218 with ARM946E-S.
64MByte SDRAM. I-Cache 8 KB. D-Cache 8 KB. Cache Enabled.
Preparing to decompress ...
100% Image in address: 0x0 - Check Sum Error!
 
  ------ Performing the Power-On Self Test (POST) ------
UART Channel Loopback Test ........................ PASS
Testing the System SDRAM .......................... PASS
Checksum Test ............................... PASS Boot1
Boot2 Checksum Test ............................... FAIL
Flash Image Validation Test ....................... PASS
 
BOOT Software Version 1.0.0.14 Built 17-May-2007 12:35:42
Network Switch based on 88E6218 with ARM946E-S.
64MByte SDRAM. I-Cache 8 KB. D-Cache 8 KB. Cache Enabled.
Preparing to decompress ...
100%

This process is repeated constantly and does not load the switch, I looked on google and found nothing.

I hope your help, thanks.

P.S. This thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to Comware-Based. - HP Forum Moderator

[Felipe_O]

I have exactly the same problem and coudn't find the answer yet.

[Apachez-]

Did you try contact the support to have this unit replaced?

Otherwise I think there is a keycombo you can press when connected through serial cable to the device to halt its bootprocess and from there be able to upload a new firmware (dont forget to update the bootrom aswell if 3com uses that).