HPE Community
Comware Based
1833785 Members
2659 Online
110063 Solutions
New Discussion

How to set SNMP trap to monitor HPE switch 5940 power supply?

 
Peter1231
Occasional Contributor

‎07-26-2018 06:38 AM

‎07-26-2018 06:38 AM

How to set SNMP trap to monitor HPE switch 5940 power supply?

Hi, we have HPE flexfabric switch 5940 with dual power supply? How to set SNMP trap to monitor HPE switch 5940 power supply? under the command "snmp-agent trap enable ?"  there is no item about power supply. Please advise, thanks in advance.

0 Kudos
1 REPLY 1
bala5
Frequent Advisor

‎08-07-2018 03:38 AM

‎08-07-2018 03:38 AM

Re: How to set SNMP trap to monitor HPE switch 5940 power supply?

Hi,

By default the basic system related trap list would be enabled.

you can configure yourself with below command.

i. snmp-agent trap enable system

ii. snmp-agent trap enable standard

 

you can view what are the trap list are enabled by issuing below commands.

>display snmp-agent trap-list

Bala
I work for HPE

Accept or Kudo

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.