stp edge-port problem : after reboot IRF, the stp edge-port functionality is lost on IRF member 2

[verpoest]

Customer have a IRF of 2 x 5900AF-48G-4XG-2QSPF+.

the release is : HP Comware Software, Version 7.1.045, Release 2311P01

Config  example of the access port is :

interface GigabitEthernet2/0/1

port link-mode bridge

port access vlan 44

broadcast-suppression pps 2000

multicast-suppression pps 2000

stp edged-port

when a pc is connected the interface go direct in forwarding state. this is ok.

but when the IRF is rebooted, and we connect a pc on an access port of unit2, it take 30 seconde before the port is forwarding.

we do not have the problem on unit 1.

when we check the config for the access port on unit2 --> the config 'stp edged-port' is still configured on the interface.

when we repeat  on the interface the command : stp edged-port

it is working fine.

but after each restart of the IRF we are loosing the stp edged-port function.

do anyone have also this problem?

[johnk3r]

Hi!

I think this has been fixed in the latest release.