2 MAPs go down at the same time

[anagamine]

Hello,



My name is Alberto and I would like to know if anyone got any similar problem.



I have installed 2 MAPs (AP3950) in the same area (roaming) using a controller WX2200. The problem is "after a sporadic time the 2 MAPs re-boot at the same time".



We have another MAPs installed in other areas, however, it happens just in this area.



The MAPs are with default configuration (auto-tunning power and channel selection).



The switch (port configuration) where these maps are connected apparently is OK.



Best Regards,



Alberto

This message was edited by anagamine on 6-24-09 @ 9:58 AM

[wirelessforever]

I would suggest you open a case with support as they will look for core dump



POM

[Knapovsky]

What version of code You have in WX2200? in init release, there were some minor problems, but they should be fixed in latest code wx version 07_00_05_06



Best regards

./miro

3Com Czech Republic

[anagamine]

Hi Miro,



We are using the version 7.0.5.6.



Hi all,



We have found the solution for this case.



The problem was in a switch where these MAPs are connected. The switch was presenting some intermittent problems and after some time caused the MAP re-boot. The switch was replaced and now it works fine.



Thank You for your attention!



Regards,



anagamine