- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- Command to check BCV configurations
Disk Enclosures
1752794
Members
6017
Online
108789
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-14-2007 04:46 AM
11-14-2007 04:46 AM
Command to check BCV configurations
Hi All,
We have hp-ux 11i servers connected with xp256 disk arrays. BCVs and CA is configured for the data volume backup.
I am new to this kind of setup. I want to know how BCVs are configured between hp systems.
Is there any command to check this configuration?
Could any one help on this?
Thanks & regards
Manoj
We have hp-ux 11i servers connected with xp256 disk arrays. BCVs and CA is configured for the data volume backup.
I am new to this kind of setup. I want to know how BCVs are configured between hp systems.
Is there any command to check this configuration?
Could any one help on this?
Thanks & regards
Manoj
Leave with out tense and try best you gets result
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-14-2007 05:15 AM
11-14-2007 05:15 AM
Re: Command to check BCV configurations
Go to the XP documentation page. You can use the WEB GUI or the CCI to display configuration. To use CCI/CLI, you need to configure some files (horcmX.conf) in a host with access to a LUN enabled as "command device".
Then you can use pairdisplay, pairmon, raiscan, etc commands to get information about your configuration.
Then you can use pairdisplay, pairmon, raiscan, etc commands to get information about your configuration.
Por que hacerlo dificil si es posible hacerlo facil? - Why do it the hard way, when you can do it the easy way?
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP