HPE Community
Disk Enclosures
1823422 Members
2437 Online
109655 Solutions
New Discussion юеВ

Re: FC60 and IBM disks

 
Dave_359
New Member

тАО10-14-2004 04:04 AM

тАО10-14-2004 04:04 AM

FC60 and IBM disks

I have recently tried adding disks into one of our SC10 enclosures, they are IBM-ESXS disks (36Gb 15k rpm ultra320). These disks show up through sam as DISK LOCKED OUT and show as status...unsupported through STM.

When the enclosure is directly attached to our server we see the disks fine. DOes anyone know of a solution?
0 Kudos
Reply
3 REPLIES 3
Darren Murray_1
Frequent Advisor

тАО11-17-2004 05:06 PM

тАО11-17-2004 05:06 PM

Re: FC60 and IBM disks

Dave,

Did you have any luck resolving this? I recently had a similar occurence.

Cheers
Daz
0 Kudos
Reply
Dave_359
New Member

тАО11-19-2004 06:26 AM

тАО11-19-2004 06:26 AM

Re: FC60 and IBM disks

Are disks were 36GB 15k, the FC60 only likes certain size disks of a certain speed - check the docs and the speed of your disks.
0 Kudos
Reply
ENeto
New Member

тАО06-24-2005 05:44 AM

тАО06-24-2005 05:44 AM

Re: FC60 and IBM disks

Dave, the IBM disk are not suported in FC60, because the version firmware ├Г┬мsn't HP. You need disk with HP firmware. I'm trying to break the firmware, and change to HP firmware, but not found tools to do it.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.