- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- Need help setting up an A3312A Jamacia enclosure
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-29-2015 12:35 PM
09-29-2015 12:35 PM
Need help setting up an A3312A Jamacia enclosure
Salutations,
This is my first post on this forum so if this thread is in the wrong section please inform me. Here is the scenario currently I am attempting to set up the A3312A enclosure. I need a little help troubleshooting though, so I begain by setting the bus's for each drive bay i numbered them 0-8 (skipped 7) then I put 4 A3714AM 18.2 gb se hard drives in the unit. I also put a scsi cord from bay a to bay b to bridge the bus's and installed a terminator on the last open slot. I am using a scsi vhdci to lvd cord to connect the array to a proliant dl380 g4. I cannot get the drives to show up. I have tried using multiple cards including a HVD card but cannot get the drives to show up in the bios. Any help would be greatly apprecated. I have a full warehouse of parts at my disposal so if it is beyond configuration and hardware related suggested replacement part numbers would be a great help.
Thank you,
B
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-30-2015 07:13 AM
09-30-2015 07:13 AM
Re: Need help setting up an A3312A Jamacia enclosure
Problem resolved, I was using the wrong type of terminator. Please close or remove this thread.