HPE Community
Disk Enclosures
1833755 Members
2916 Online
110063 Solutions
New Discussion

No SCSI devices detected at boot.

 
Ayman Altounji
Valued Contributor

‎06-24-2002 04:00 PM

‎06-24-2002 04:00 PM

No SCSI devices detected at boot.

The motherboard of a Proliant 1600 was unstable. Tried to change the motherboard, and the result now is that the server gives the message "No SCSI devices detected" at boot. When running the diagnostic utility, it reports no problems with the disks. This is a 221 controller, with two 9,1 scsi drives in a mirror ( Raid 1 ). Tried to change back to the old motherboa rd, with no luck. The Motherboard is using the latest firmware.

I really appreciate any help, it is strongly needed :)
0 Kudos
Reply
1 REPLY 1
Mark Cloutier
Respected Contributor

‎07-01-2002 04:00 PM

‎07-01-2002 04:00 PM

Re: No SCSI devices detected at boot.

If you are using the 221 to boot from then this is normal as nothing is attached to the on-board SCSI port. What you want to see is a Logical drive found message.
We are here for a good time, not a long time!
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.