HPE Community
Disk Enclosures
1752794 Members
7363 Online
108789 Solutions
New Discussion юеВ

Re: VA7410 armdsp

 
SOLVED
Go to solution
billieperez
Occasional Advisor

тАО07-09-2007 06:06 AM

тАО07-09-2007 06:06 AM

VA7410 armdsp

Hello,

I have an rp5470 running HP-UX 11.11, commandview 1.09 connected to a VA7410 and was previously able to run my arm commands referencing the alias name -- armdsp -a . I noticed today that I am not able to use the alias (or SN), but can only run just armdsp to have the information displayed of an armdsp -a . Any ideas as to why this is and how to get it back to being able to run commands using the alias?
0 Kudos
3 REPLIES 3
Torsten.
Acclaimed Contributor

тАО07-09-2007 07:17 AM

тАО07-09-2007 07:17 AM

Solution

Re: VA7410 armdsp

Any error output?

I assume somebody wrote a script and put it in a directory where it would be called before the system finds the real binary.

Check

whence armdsp

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
billieperez
Occasional Advisor

тАО07-09-2007 11:09 PM

тАО07-09-2007 11:09 PM

Re: VA7410 armdsp

ah, thanks for the response - there was an alias set up!
0 Kudos
billieperez
Occasional Advisor

тАО07-09-2007 11:10 PM

тАО07-09-2007 11:10 PM

Re: VA7410 armdsp

closed
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.