HPE Community
Disk
1837628 Members
3123 Online
110117 Solutions
New Discussion

Re: sc1000-- only recognizes half the drives-- help!

 
jglass02
New Member

‎04-08-2006 01:14 PM

‎04-08-2006 01:14 PM

sc1000-- only recognizes half the drives-- help!

Just purchased an sc10 .. filled it up with slim line 76 gig drives.
I connect the sc1000 to my hp netserver 6000r, and only half the drives are recognized.
What gives? I am using only a simplex connection--I have dual scsi 2 ultra cards in the sc10, but only the "a" card is being used, and only the "a" port on that card is being used. Port "b" on the first scsi card is terminted.
0 Kudos
2 REPLIES 2
Torsten.
Acclaimed Contributor

‎04-09-2006 10:37 PM

‎04-09-2006 10:37 PM

Re: sc1000-- only recognizes half the drives-- help!

I assume this is a SC10 (A5272A).

Take a look at the DIP switches at the backside. I'm sure there is "split bus" configured. So all even slots are on one bus, all odd slots are on another bus. If you switch off the system and set the switch to full bus, you will have all disks on only one bus.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Luk Vandenbussche
Honored Contributor

‎04-09-2006 11:13 PM

‎04-09-2006 11:13 PM

Re: sc1000-- only recognizes half the drives-- help!

Hi,

Here you find the manuals

http://h20000.www2.hp.com/bizsupport/TechSupport/DocumentIndex.jsp?contentType=SupportManual〈=en&cc=us&docIndexId=179111&taskId=101&prodTypeId=12169&prodSeriesId=33747
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.