HPE Community
General
1842701 Members
2404 Online
110208 Solutions
New Discussion

How do I activate ALB in commandline

 
Jesper Taanum-Willumsen
Occasional Contributor

‎04-03-2008 02:32 AM

‎04-03-2008 02:32 AM

How do I activate ALB in commandline

Hi

I install MPIO unattended from Altiris.
I want to set the ALB parameter in the same job, but I don't know how. I presume it is a parameter in the update.iss file but I cannot find the documentation. Any ideas?

Regards
Jesper Taanum-Willumsen
Energinet.dk
0 Kudos
1 REPLY 1
Uwe Zessin
Honored Contributor

‎04-03-2008 04:32 AM

‎04-03-2008 04:32 AM

Re: How do I activate ALB in commandline

I am not sure you can make it a default setting, but you can change it from the command line - session log attached.
.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.