HPE 3PAR StoreServ Storage
1748262 Members
3609 Online
108760 Solutions
New Discussion

Starting synchronous remote copy with low priority

 
stomko
Occasional Contributor

Starting synchronous remote copy with low priority

Hi

We have to stop RC groups one by one for some maintenance operations. Starting groups again will cause a large impact to all hosts: 30 - 40 ms delays before the sync is ready. Starting only one group with 2 TB of volumes inside takes 20 minutes before the sync state is green and the whole time it causes delays.

Is there an option to start remote copy sync again with lower priority?

2-node 8200, 3.2.2 MU4

1 REPLY 1
Sheldon Smith
HPE Pro

Re: Starting synchronous remote copy with low priority

No. The "startrcopygroup" command has no priority option.
It would be a trade-off, but could you wait and start it later during off-hours? You mentioned multiple RCGs. Can you start each one using "startrcopygroup -wait" so only one is re-syncing at a time?


Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company

Accept or Kudo