Adding CPU and Memory in rp5470

[Rgomes]

Hi All,

I have to add 2 more CPUs( with license) and 1G of RAM in a rp5470 server. I have the full document on how to do it. I want to know how should I add this license or how to integrate these 2 CPUs with OS.

Thanks in advance,
Richard

[Michael Tully · Accepted solution]

You don't need to do anything. Just install the CPU's and start the system. If they have been installed correctly, the system will recognise them and automatically start to use them. You can interrupt the system start up process and check them from GSP if you wish but it not necessary. Only other thing I can suggest is make sure that they all have the same firmware level.

[Naveej.K.A]

If you are going to add memory, you have to see whether there are free slots to put the memory. Otherwise you may need to go for memory extenders. Normally memory goes in pairs.

regds
naveej

[Rgomes]

Hi Michael, regarding the firmware---yes I should check it. Thanks for pointing it out.

Hi Naveel, I have 2 more free slots( from cstm output) to add-on. Thanks for your input.

regards,
Richard