HPE Community
HPE Aruba Networking & ProVision-based
1827691 Members
3325 Online
109967 Solutions
New Discussion

2920 Stack configuration: Failback commander & member priority

 
Patrick Terlisten
Honored Contributor

‎04-02-2014 11:28 PM

‎04-02-2014 11:28 PM

2920 Stack configuration: Failback commander & member priority

Dear members,

 

I've configured a pair of HP 2920-48G switches as a stack. It works like a charm, but I've two questions:

 

After the commander switch failed, the standby switch becomes master. If the commander comes back, no failback occurs. Is this behaviour expected or can I configure a failback?

 

I can configure a member priority. Is a higher (up to 255) or lower number better? What does this priority value exactly affect?

 

Thanks for advice.

 

Regards,

Patrick

Best regards,
Patrick
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.