HPE Community
HPE Aruba Networking & ProVision-based
1831185 Members
3169 Online
110021 Solutions
New Discussion

Cannot access flash, show flash returns 0 both on primary and secondary image

 
George_Farcas
Occasional Contributor

‎10-30-2014 12:04 PM

‎10-30-2014 12:04 PM

Cannot access flash, show flash returns 0 both on primary and secondary image

This is the output of the command

 

Office2# show flash
Image Size(Bytes) Date Version
----- ---------- -------- -------
Primary Image : 0
Secondary Image : 0
Boot Rom Version: W.14.04
Default Boot : Primary

 

I have tried to copy from or copy to flash but it doesn't work and it does not let me upgrade the firmware. I am afraid that in case of a restart I may loose the switch ?

 

Should I call warranty ?

0 Kudos
1 REPLY 1
bibma
Occasional Advisor

‎11-03-2014 09:14 PM

‎11-03-2014 09:14 PM

Re: Cannot access flash, show flash returns 0 both on primary and secondary image

Yes warranty.. Reporting 0 doesnt look ok..

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.