Help to interconnect a Cisco router 1900 with procurve switcher 2910

[danielvillao]

Dear

i would like to know witch is the best way to integrate the cisco router with the hp switcher, at this time the HP switcher is routing between three vlans than i created  for the technical network, the internet carrier installed the cisco router to access internet for the andimistrative network some client of this network need to see the technical network this is the issue!

ill appreciate your help and comments and any suggestion,

regards

[nsnidanko]

I am quite confused on what you're trying to achieve. My guess you want to have Cisco route between VLANs as well as the "Internet". You need to create a trunk with all 3 VLANs going to the router. Next on the cisco create 3 sub-interfaces for each vlan and create static routes for all networks. Finaly on the end clients you need to put IP address you assigned to sub-interfaces as the gateways for corresponding networks accordingly (depends how you distribute addresses: DHCP or static). Don't forget to disable L3 capability on the switch so you don't route in both places as it will get confusing.

Or another option: set up cisco router on a separate VLAN and configure default route on HP switch to this cisco IP.