HPE Community
HPE Aruba Networking & ProVision-based
1834935 Members
2221 Online
110071 Solutions
New Discussion

How to config the 2510G stacking with Linux bonding

 
machiasiaweb
Occasional Contributor

‎05-17-2011 12:18 AM

‎05-17-2011 12:18 AM

How to config the 2510G stacking with Linux bonding

Hi,

 

I have two 2510G now.  I am planning to config them into stacking mode.  Also, I have another Linux machine which running RHEL and ethernet is configed to bonding now. 

 

I would like to know is it I need to config those ports with connected to Linux machine by trunking mode?

0 Kudos
1 REPLY 1
Helper
Valued Contributor

‎05-17-2011 06:51 AM

‎05-17-2011 06:51 AM

Re: How to config the 2510G stacking with Linux bonding

Hi,

 

HP E-Series Stack is not IRF or VSS or Chassis Bonding. This Stack commander cisco feature like.

in a stack configuration you cannot split your LACP/trunk on two devices, the only things you can do running stack or not is to configure Linux NIC Bonding with higher level agregation (L3 or L4 bonding).

 

Bye.

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.