HP 2620 Switch

[lecarbajalp]

Hello i configured a sw 2620 as an acces switch I defined 1 vlan in order to connect phones there, i already integrate with my Cisco Switch 3750X, my only issue with the HP is that i can not ping to the VLAN IP even its connected some equipments to the switch, i attached the configuration.

vinterface 25
   speed-duplex 100-full
exit
interface 26
   speed-duplex 100-full
exit
interface 28
   speed-duplex 1000-full
exit
vlan 1
   name "DEFAULT_VLAN"
   untagged 1-28
   ip address dhcp-bootp
   exit
vlan 6
   name "VLAN6"
   ip address 10.10.4.10 255.255.255.0
   tagged 23
   exit
snmp-server community "public" unrestricted
spanning-tree priority 0 

The spanning tree is not enable because i will use this HP connected like daisy chain,

The idea to reach the IP is to monitor the equipment by snmp

I can not even reach the HP by ping even i configured the port in the cisco like access port.

Thank you.

P.S. This thread has been moevd from Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. - Hp Forum Moderator

[Pourl]

Hi, is port 23 on hp switch the uplink to the cisco switch?

Is the cisco switch uplink configured as trunk and allows all vlan or at least vlan 1 and 6?

routing and vlan 6 also have to be configured on cisco switch.

Furthermore the hp Switch need a default gateway. if you ping vlan 6 ip from a client in vlan 1 you won't be able to reach the switch.

i would say vlan 6 is your mgmt vlan, so vlan 1 doesnt need a (dhcp-)ip....

Pourl