HP Procurve 5412zl with Windows 2012 Radius NPS

[felix107]

Hi Everyone,

I'm having some trouble with setting up 802.1x for wired conneciton. Essentially, I'm starting out by testing a mac book pro connect via the HP Procurve 5412zl switch and the switch is pointed to the Windows Radius Server 2012.

Based on the user AD authenication and the group that the user belongs to the mac book pro will be configured to a different vlan and allowed access to vlan and it they are not authenicated they are sent to another vlan.

Here is the swtich config.

radius-server host xxx.xxx.xxx.xxxx key "xxxxxxxxxxx"
...
aaa server-group radius "RAD" host xxx.xxx.xxx.xxx
aaa authentication port-access eap-radius server-group "RAD"

I've been reading a lot about the radius configuration for windows server, but a lot of the references Windows 2008 and the documentation is very limited for Windows 2012. The closest thing I found was how to setup via the CISCO switch.

Any help would be greatly appricated.

Please note that with the following configuration, FreeRadius is working perfectly fine.

Thanks