HPE Community
HPE Aruba Networking & ProVision-based
1834710 Members
2617 Online
110069 Solutions
New Discussion

The "openflow" command is not work on HP 2920-24 switch

 
wang8018
New Member

‎05-21-2014 06:32 PM - last edited on ‎05-25-2014 07:03 PM by

‎05-21-2014 06:32 PM - last edited on ‎05-25-2014 07:03 PM by

The "openflow" command is not work on HP 2920-24 switch

HI, I want to set up a openflow experiment network. But when I input the commond "openflow enable" in the CLI, the system return the result" invalid input: openflow". The firmware version on the switch is WB15.15. I want to know how to solve this problem? Thanks a lot. 

 

P.S. This thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. -HP Forum Moderator

0 Kudos
1 REPLY 1
Sietze Reitsma
Respected Contributor

‎05-25-2014 12:38 PM - edited ‎05-25-2014 12:41 PM

‎05-25-2014 12:38 PM - edited ‎05-25-2014 12:41 PM

Re: The "openflow" command is not work on HP 2920-24 switch

first you need to be in config mode ;-)

 

2920# configure terminal

 

 from here you can start configuring Openflow

Openflow

Openflow instance ... etc etc

 

after every command you can enter "help" for more information

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.