HPE Community
HPE Aruba Networking & ProVision-based
1833479 Members
2512 Online
110052 Solutions
New Discussion

VLAN Management 2510 and 1910

 
LucaP.EOS
Occasional Advisor

‎02-25-2014 08:50 AM - edited ‎02-25-2014 08:51 AM

‎02-25-2014 08:50 AM - edited ‎02-25-2014 08:51 AM

VLAN Management 2510 and 1910

I need to setup a VLAN Management for switch 1910 and 2510 that are connected.

 

My management VLAN is n.3 and network 10.0.3.x.

I have a HP 3500yl layer 3 as main switch.

On the port used to connect 3500 to 2510, I set the port as tagged for all VLAN including VLAN 3 for management.

 

I have more other 2510 without problem, the problem is only with 1910.

I would like to set all management ip on 10.0.3.x network and permit all VLAN traffic between switches.

 

I can connect to 1910 only if I set the port for management as untagged on VLAN 3.

But If I set the port on 1910 connected to 2510/3500 as tagged then I can't connect to VLAN 3 Management.

 

I attach configuration for 1910 and 2510.

 

Can You help me?

 

Best regards,

Luca Passioni

 

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.