Cannot find the HSV110 controller in EVA5000

[Ram_Mohan]

Hi Experts,

I am trying to configure an EVA5000 storage system. The EVA 5000 system got following gardware.
1x A Compaq DL380 Plll Machine (with Emulex 1 HBA FCA2408 PartNo 343073-B21)
2x HSV110 Controllers
4x Switches
4x HDD shelfs.

On the DL380 machine I installed the Windows 2003 SP1 and Command view 6.0. Also I installed the latest driver for the Emulex HBA.

But in the CommandView I couldn't see the HSV controller. It say's No controller found.

I am not sure is there any additional software is needed to configure this EVA5000? Can any boy help me?

Thans in advance
Ram

[Torsten.]

Did you check/adjust the zoning?

The management server must be able to reach the EVA - you should create a zone that includes the server and the EVA controller (s).

[Rob Leadbeater]

Hi Ram,

How do you have things connected - specifically what is the fibre on the DL380 connected to ??

Given your description of 4 x switches, it sounds like these might be the back end switches used to connect the HSV110 controllers to the disk enclosures. The DL380 shouldn't be connected to these...

Hope this helps,

Regards,

Rob

[Ram_Mohan]

I hope that could be a problem. I am new to this EVA5000. Can you please tell me how create the zone.

Thank you

[Ram_Mohan]

Yes. You are right. The disc controllers and HSV110 are connected to that switch.

Then how shoul I connect the DL380?

Thank you.

[Torsten.]

Here are the manuals:

http://h20000.www2.hp.com/bizsupport/TechSupport/DocumentIndex.jsp?contentType=SupportManual〈=en&cc=us&docIndexId=179111&taskId=101&prodTypeId=12169&prodSeriesId=321347

You need to connect the EVA and the server to a "real" SAN switch!

[Rob Leadbeater · Accepted solution]

OK. The back end switches should only be used to connect between the controller ports (1A, 1B, 2A, 2B) and the drive enclosures.

You need to connect the DL380 to a separate SAN switch. That SAN switch will then have connections to ports FP1 and FP2 on the HSV110s.

Cheers,

Rob

[Ram_Mohan]

Thanks Rob.
Give me some time. I'll confogure with a SAN switch and come back to you.

Thank you

[Ram_Mohan]

Excellant. As you said I connected the DL380 to a sanswitch(pn:322118-B21 HP Storage SAN switch 2/16) and I connected the SAN switch to port FP1. Now I can see the EVA in the command view.

I again thank you all participated in this conversation.

Ok. I got another problem now. I created a Vdisk, added the DL380 as host and I present the Vdisk to host. But I can't see the disk in the DL380. Event I rescan the disk in disk manager(win2k3) I couldn't see the disk.

Can anybody advice me.

Thankyou
Ram

[Rob Leadbeater]

Hi,

If you've only connected one port from one controller to the SAN switch then you may not see the disks...

Try connecting all four FP ports to the SAN switch and see if that makes any difference...

However, are you planning on using this system for production purposes ? It's not recommended to use the Command View EVA server for anything other than Command View...

Cheers,

Rob