HPE Community
HPE EVA Storage
1754857 Members
4899 Online
108827 Solutions
New Discussion юеВ

NPIV configuration on HP StorageWorks 8/20q SAN Switch

 
Santhosh Ramesh
Advisor

тАО06-03-2009 01:06 PM

тАО06-03-2009 01:06 PM

NPIV configuration on HP StorageWorks 8/20q SAN Switch

How do I enable NPIV on the HP StorageWorks 8/20q SAN switch? I have the latest firmware installed (8.00.2.02).

Thanks,
-Santhosh
0 Kudos
Reply
2 REPLIES 2
Sameer_Nirmal
Honored Contributor

тАО06-03-2009 02:58 PM

тАО06-03-2009 02:58 PM

Re: NPIV configuration on HP StorageWorks 8/20q SAN Switch

You can enable NPIV on a port by port basis by changing the port mode to TR.

(admin-config) #> set config port

Refer the switch command line interface guide as well.

http://h20000.www2.hp.com/bizsupport/TechSupport/CoreRedirect.jsp?redirectReason=DocIndexPDF&prodSeriesId=3662821&targetPage=http%3A%2F%2Fbizsupport2.austin.hp.com%2Fbc%2Fdocs%2Fsupport%2FSupportManual%2Fc01376638%2Fc01376638.pdf
0 Kudos
Reply
Sivakumar MJ._1
Respected Contributor

тАО06-03-2009 11:08 PM

тАО06-03-2009 11:08 PM

Re: NPIV configuration on HP StorageWorks 8/20q SAN Switch

Santhosh,

Check this document..

http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c01658415/c01658415.pdf
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.