problem securepath with EVA3000

[Luis Blanco]

SO HP-UX 11.23
march 2006

with securepath 3.0F sp1
run autopath display
display
AUTOPATH : no SecurePath device found

__?????????






when run autopath discover
and autopath display
itanium1> autopath discover
AUTOPATH : discovery of new paths / LUNs will be effective only if ioscan and i
nsf -e are executed prior to autopath discover
AUTOPATH : discover in progress ...
autopath display
AUTOPATH : discover successful
itanium1> autopath display

AUTOPATH : no SecurePath device found




when run ioscan -fnC disk
disk 3 0/2/1/0.1.0.0.0.0.1 sdisk CLAIMED DEVICE HP HS
V200
/dev/dsk/c4t0d1 /dev/rdsk/c4t0d1
disk 4 0/2/1/0.1.1.0.0.0.1 sdisk CLAIMED DEVICE HP HS
V200
/dev/dsk/c6t0d1 /dev/rdsk/c6t0d1

[Uwe Zessin]

There is some inconsistency between the thread subject and the data:

HSV200 is the controller identification for EVA4000 and EVA6000. The EVA3000 in Active/Passive mode (VCS < V4) reports itself has HSV100) and in Active/Active mode (VCS >= V4) has HSV101.


Assuming that "ioscan" is correct:
- you first need to run "autopath discover"
- and then run "ioscan"

[Luis Blanco]

run autopath discover
and
autopath display

itanium1> autopath discover
AUTOPATH : discovery of new paths / LUNs will be effective only if ioscan and i
nsf -e are executed prior to autopath discover
AUTOPATH : discover in progress ...
autopath display
AUTOPATH : discover successful
itanium1> autopath display

AUTOPATH : no SecurePath device found

[Uwe Zessin]

Interesting... I could have sworn that it had to be run the other way round. Anyway.

Did you accidently install the workgroup edition of Secure Path? This one does not work with any EVA.

[Luis Blanco]

run swlist

HPswsp A.3.0F.01F.00F HP StorageWorks Secure Path Devic
e Driver and utilities for Active-Active Disk Arrays