td error code during boot up

[ecorban]

hi

I get the following error code while booting a host with 5158a on a brocade san :

0/4/0/0: Fibre Channel Driver detected a parse error in the FLOGI/PLOGI response
returned by nport ID 0x1f026. FLOGI/PLOGI Fail Code = 0x2.

0/4/0/0: Unable to access previously accessed device at nport ID 0x1f026.


what does the error code 0x2 mean ?

[David Child_1]

Eddie,

Unfortunately I don't know what error code 0x2 for the FLOGI/PLOGI fail code is, but here is a thought;

Make sure the switch port where the storage is plugged into didn't move. You should be able to move the host HBA to a different port without any problems (as long as you are using WWN zoning), but if you move the storage side port it will change your controller info (and hardware address).

Verify the correct storage is plugged into nport ID 0x1f026 on the switch. I believe it has to be in that port for it to work.

David

[ecorban]

thanks. this issue is resolved. this PID was a virtual PID through a san router.