Oneview LIG Load Balance setting

[craigpennock]

Hello,

I am receiving this warning:
"The logical interconnect is inconsistent with the logical interconnect group XXXXXX.
The following update will be performed automatically:

1. - For uplink set xxxxxx, Load Balance mode will be updated from SourceAndDestinationMac to None.
2. - For uplink set xxxxxx, Load Balance mode will be updated from SourceAndDestinationMac to None.

Resolution 

The logical interconnect can be made consistent with its logical interconnect group via update from group. The logical interconnect or group may also be edited to manually restore consistency. If consistency is not desired, this alert can be cleared."

I would like to manually update the LIG to SourceAndDestinationMac but I cannot find the place to set this.

I have a case raised but so far I am having no luck

Thanks

Craig

[AmRa]

Hi Craig,

Are you facing isue on Synergy Frame?

If yes, Are you runiing setup with 4.20.01 upgrade?

If yes, then in order to resolve the issue please perform the following task:

Updating from Group will correct the incorrect DB setting that was introduced with the OneView upgrade.
Performing an Update from group and is safe with no impact to any traffic using the LI.