Restore HPE Oneview c7000 from backup --new alert

[joe_mama]

I successfully restored from backup this morning. However I'm getting an appliance alert. "The appliance has been started under circumstances where the database may not match the managed environment. To prevent unintentional allocation of duplicate MAC address, world wide names and serial numbers, existing ranges have been disabled. For these identifiers, replacement ranges have been created. If none of these identifiers have been allocated since the time when the database matched the managed environment, it is safe to re-enable the range and remove the replacement range. When keeping a replacement range, ensure it does not conflict with addresses or identifiers used in the environment."

How do I re-enable the range, or resolve this alert?

Thanks in advance,

-joe-

[DanCernese · Accepted solution]

This is normal as a protection explained by the alert.

HPE OneView => select Settings > Addresses and Identifiers

Click Actions > Edit

Enable the original start and end parameters, disable the worldwide names that were created during the restore.

[support_s]

System recommended content:

1. HPE OneView 6.5 User Guide for VMs | Restore an appliance from a backup file using the HPE OneView GUI

2. HPE OneView 7.0 User Guide for VMs | Restore an appliance from a backup file using the HPE OneView GUI

Please click on "Thumbs Up/Kudo" icon to give a "Kudo".

Thank you for being a HPE valuable community member.