p400 to p410 issue

[Toddmsn99]

I configured a logical drive on a p200 controller. There was 3 x 3TB drives configured in raid5. It only showed the drives at 2TB which was fine at the time. I then upgraded to a p400 controller. I moved the drives to the new controller and the logical drive showed correctly. I then upgraded to a p410 controller. The logical drive does not show. it only shows 3 x 3tb drives "unassigned" and the controller is "not configured". Ok, so I moved the drives back to the p400. At boot the controller shows a logical drive found but an error saying the drive is the incorrect size. The logical drive is not available.

[Toddmsn99 · Accepted solution]

The controller said failed drives all data lost, however there was an option to reenable drive with data loss. I reenabled the logical drive and all the data was still intact.