HPE Synergy
1823791 Members
4614 Online
109665 Solutions
New Discussion

VC4040F8 Interconnect Default login?

 
SOLVED
Go to solution
Mitjes
Occasional Contributor

VC4040F8 Interconnect Default login?

In progress of reseting a few Synergy systems. I cant seem to find any default login information for the interconnect.  I've already tried netop/netoppwd.

3 REPLIES 3
DanCernese
HPE Pro

Re: VC4040F8 Interconnect Default login?

That's because there is no default.  Once configured as part of an LE, the LI has an action to enable it. [edit] it's not the LI.

The interconnect has an option to enable it:

2023-08-15_13-00-32.jpg



I work at HPE
HPE Support Center offers support for your HPE services and products when and how you need it. Get started with HPE Support Center today.
[Any personal opinions expressed are mine, and not official statements on behalf of Hewlett Packard Enterprise]
Accept or Kudo
Mitjes
Occasional Contributor

Re: VC4040F8 Interconnect Default login?

So would resetting the encosure to defaults reset the interconnects as well? I dont have HP OneView.....

Screenshot 2023-08-15 121041.png

 

Screenshot 2023-08-15 120845.png

DanCernese
HPE Pro
Solution

Re: VC4040F8 Interconnect Default login?

The firmware running on the HPE Synergy Composer is in fact "HPE OneView" and there's a button right there on your screen to start it, so yes, you have HPE OneView.

You cannot do anything at all in Synergy without HPE OneView.. and the "reset" of the enclosure you're talking about is typically performed by deleting the logical enclosure.  If you need to ensure the individual modules are factory-default-reset, you may swap their positions (e.g. slot 3 <=> 6) and that will perform it again.

2023-08-15_13-16-02.jpg



I work at HPE
HPE Support Center offers support for your HPE services and products when and how you need it. Get started with HPE Support Center today.
[Any personal opinions expressed are mine, and not official statements on behalf of Hewlett Packard Enterprise]
Accept or Kudo