SPOP configuration not getting completed

[Popy]

Hi all,
I was trying to configure spop server. while spop initilization after giving host name and ip address (in fact it istaking automatically ) it says DNS suffix is invalid, and its exits from there.Wins is a must for SPOP?? Any suggetions will be highly appreciable.
Raneesh Vijayan

[Frauke Denker_2]

Hello,
did you set the dns suffix? Verify it with "ipconfig /all". The field "Primary DNS Suffix" should contain a valid suffix. This is needed for the SPOP installation as discribed in the "SPOP Configuration and Upgrade Guide":
1) Right-click the HP ISEE SPOP icon and select Properties.
2) Select Network Identification and click [Properties].
3) Click [More], enter the DNS Suffix, and click [OK].
4) Accept changes as you exit the Network Identification Properties, and the
reboot request by clicking [Yes] at each window. This results in a system reboot.
Regards
Frauke

[Popy]

Hello Frauke,
You were right.I just followed your suggetion
Now the SPOP server is working fine.
Thank you Frauke, I appreciate it.
Regards
Raneesh Vijayan