Add and activate cell to Partition

[meekrob]

hi sirs,
i need help to add and activate all my cell installed on rx7620 integrity server,
HP-UX 11.23 has been installed on the server
[mp] MP:CM> cp

--------+--+
Cabinet |0 |
--------+--+
Slot |01|
--------+--+
Part 0 |.*|

[mp] MP:CM> du

The following MP bus devices were found:
+---+----+----+-----+-----+-------+-----+
| | | | | | | |
| | |LAN\| Sys | | IO | |
|Cab| MP |SCSI|Bkpln|Cells|Chassis| BPS |
| # |M S|0 1| | 0 1 | 0 1 | 0 1 |
+---+----+----+-----+-----+-------+-----+
| 0 |* *| *| * | * * | * * | * * |
+---+----+----+-----+-----+-------+-----+

i tryed this command:
parmodify -p0 -a0:base:y:ri

and then shutdown -R then i got an error:


EFI version 1.10 [14.61] Running on GenuineIntel Itanium(R) 2 Processor
EFI server rx7620 SAL [14:34:57] - HP
Loading 'ULTRA160_SCSI'...
driver: Image ULTRA160_SCSI loaded at 40FD5BE000-40FD5FE000. Returned Success
Loading 'BRM5701_LAN'...

Copyright (c) 2000-2005 Broadcom Corporation
Broadcom NetXtreme Gigabit Ethernet EFI driver v7.0.10

driver: Image BRM5701_LAN loaded at 40FD644000-40FD67E000. Returned Success
Loading 'FPSWA'...
driver: Image FPSWA loaded at 40FD554000-40FD5BE000. Returned Success
POSSE Library is loading...
EFI Shell version 1.10 [14.61]
Device mapping table

acpiconfig: Warning, the current ACPI configuration mode
does not match across the cells.
Please use the 'acpiconfig' command to set the desired
ACPI configuration mode, then issue a global cold reset.

i re-genesis the partition
MP>cm
CM>cc
and i saved the HPux 11.23 installed on the disk with the old configuration.

Thank you in advanced

[Torsten. · Accepted solution]

Issue a "acpiconfig default" from EFI.

Boot up the server and run "parmgr" to assign the cell.
You can also go to the SMH
your_server:2301/parmgr
to do this.

[meekrob]

done

thank you

[Torsten.]

Please read this too:

http://forums1.itrc.hp.com/service/forums/helptips.do?#33