Configure L3 Interface HP A5800 series

[cypris]

Hi all,

I have an HP A5800 series L3 Switch that I am trying to configure one of the "TenGigabit" interfaces with a GB GBIC as a routed interface.

I read the manual to change the default state of the port from a L2 Bridge to an L3 Route port by:

enter the interface configuration and change the Port Link-mode state to ROUTE.

When I enter the following: port link-mode route

I get this error:  Action fails: Not enough resources

Can someone enlighten me on what that message means or what I may be missing here?  Thanks for your help.

[cypris]

It was the Firmware, upgraded to latest for the 5800 series and viola - it works..