- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- LAN Routing
- >
- Procurve - add a static route
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-11-2014 07:45 AM
09-11-2014 07:45 AM
Procurve - add a static route
HI all
Is it possible to add a static route opr a mac address to a specific port on a hp procurve 2920?
Thanks in advance
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-11-2014 03:16 PM
09-11-2014 03:16 PM
Re: Procurve - add a static route
yes. The manual has a layer3 section that tells you what kind of routing is supported.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-12-2014 05:03 AM - edited 09-12-2014 05:04 AM
09-12-2014 05:03 AM - edited 09-12-2014 05:04 AM
Re: Procurve - add a static route
I solved the problem on my own and I want to share the solution.
We have two terminal server with NLB on esxi host.
With default configuration all packets are sent broadcast to all ports of your switch. (in my company, network overloads caused a lot of blocks in our warehouse management software)
As recommended by vmware, I activated the multicast with igmp, but the switch doesn't memorize mac address of the physical network card of the server and packets was still in broadcast.
The solution is to activate IGMP on the vlan where the server is connected, because in default configuration the switch can't correctly recognize the protocol of the packets.
This is the command:
vlan <number> ip igmp
Hope this helps
David