VPLS - VSI always down

[Standula]

Hi, in lab i have VSI always down on PE. I configure BGP auto-discovery LDP PW

I dont known how to get more debug informations from switch about VPLS and VSI discovery communication.

PE is 5920 named as HPE 2

MPLS and ldp are running, OSPF is setup, BGP L2VPN is running, Service instance is attached and up, VSI instance is up,  but no PW is created, VSI is always down. 

Peer IP 172.24.255.1

[HPE2]display mpls ldp peer 
Total number of peers: 1
Peer LDP ID             State         Role     GR   MD5  KA Sent/Rcvd
172.24.255.1:0          Operational   Active   Off  Off  275/275

[HPE2]display bgp peer l2vpn 

 BGP local router ID: 172.24.255.20
 Local AS number: 64599
 Total number of peers: 2                 Peers in established state: 1

  * - Dynamically created peer
  Peer                    AS  MsgRcvd  MsgSent OutQ PrefRcv Up/Down  State

  172.24.255.1         64599       78       76    0       1 01:09:05 Established
  172.24.255.30        64599        0        0    0       0 01:46:26 Connect  


[HPE2]display l2vpn vsi verbose 
VSI Name: aaa
  VSI Index               : 0
  VSI State               : Down
  MTU                     : 1500
  Bandwidth               : -
  Broadcast Restrain      : -
  Multicast Restrain      : -
  Unknown Unicast Restrain: -
  MAC Learning            : Enabled
  MAC Table Limit         : -
  Drop Unknown            : -
  ACs:
    AC                               Link ID    State   
    XGE1/0/3 srv10                   0          Up 


[HPE2]display bgp update-group l2vpn 

  Update-group ID: 0
  Type: IBGP link
  4-byte AS number: Supported
  L2VPN signaling (VPLS): Supported
  L2VPN signaling (VPWS): RFC mode
  L2VPN auto-discovery: RFC mode
  Minimum time between advertisements: 15 seconds
  OutQ: 0
  Members: 1
    172.24.255.1

On Peer L2VN BPG update group is created

<PE_Taborska_1790_5930>display bgp update-group l2vpn 

  Update-group ID: 0
  Type: IBGP link
  4-byte AS number: Supported
  L2VPN signaling (VPLS): Supported
  L2VPN signaling (VPWS): RFC mode
  L2VPN auto-discovery: RFC mode
  Minimum time between advertisements: 15 seconds
  OutQ: 0
  Members: 1
    172.24.255.20

<PE_Taborska_1790_5930>display bgp peer l2vpn 

 BGP local router ID: 172.24.255.1
 Local AS number: 64599
 Total number of peers: 3                 Peers in established state: 1

  * - Dynamically created peer
  Peer                    AS  MsgRcvd  MsgSent OutQ PrefRcv Up/Down  State

  172.24.255.6         64599        0        0    0       0 01:12:20 Connect    
  172.24.255.20        64599       78       80    0       0 01:11:23 Established
  172.24.255.30        64599        0        0    0       0 01:12:20 Connect 

<PE_Taborska_1790_5930>display mpls ldp peer 
Total number of peers: 2
Peer LDP ID             State         Role     GR   MD5  KA Sent/Rcvd
172.24.255.20:0         Operational   Passive  Off  Off  300/300
5.39.201.157:0          Operational   Passive  Off  Off  303/302

Thank for tips

[jmpk]

Hello ,

Can you please let me know are you still seeing it down ? If so please share the configuration from both peer. 

Also refer below VPLS configuration guide and verify the config you have implemented.

http://h20628.www2.hp.com/km-ext/kmcsdirect/emr_na-c04566745-4.pdf