Finding IP of MSA 2050

[theKtechex]

Hello, 

One of the hard disks on my MSA 2050 went bad (had a  yellow light), got a replacement and per the manual I should have been able to hot swap it, but putting in the new one, the lights only blink for a moment and then goes dark. 

So I like to get into the magement console, but the IPs I have for it don't seem to work while ethernet to either console on the backside or the default IPs. I do have a cable to connect to the CLI port, but not sure what to do beyond that? Is there a page listing commands I can run from cmd to find its IP?

Thanks in advance. 

[support_s]

System recommended content:

1. HPE MSA 2050 User Guide

Please click on "Thumbs Up/Kudo" icon to give a "Kudo".

Thank you for being a HPE valuable community member.

[Cali]

Here are some useful commands for you:

show network-parameters

set network-parameters ip xxx.xxx.xxx.xxx netmask xxx.xxx.xxx.xxx gateway xxx.xxx.xxx.xxx controller a
set network-parameters ip xxx.xxx.xxx.xxx netmask xxx.xxx.xxx.xxx gateway xxx.xxx.xxx.xxx controller b

show system

show vdisks

show disks

Cali

[theKtechex]

@Cali Hi, 

Thanks for that info, was useful once I was able to get into the MSA but only through a putty session. I see the disk I added as being avaliable in slot 11, anyone know the commands to add it to the current pool to replace the bad disk?